This message informs the user that it is in unauthorized access, and does not interfere with any settings on the router. When an unauthorized user attempts to access your router, you can show the user a message. Step 5: Viewing a Message for Unauthorized Contacts You will see that your password was encrypted as shown in the image below, where you review the configuration of your Cisco Router again. You can use the following command in the CLI to disable the enable password command. Password: ⇒ Burada cisco123456 parolası denendi ve başarılı olarak giriş yapıldı. Password: ⇒ Burada cisco123 parolası denendi ve başarılı olmadı. ISTANBUL(config)#enable secret cisco123456 If you enable it on your router, your Enable Password will be disabled! ISTANBUL# You must use the Enable Secret command in the router’s config mode to encrypt the enable password that appears in the running-config. To prevent this, you must encrypt the password. When you run the show running-config command on your router, you can see from the following image that the enable password you created is visible.īecause passwords created with Enable Password send as cleartext, you can see the password in the show running-config. When you look at the image below, you may see that a password is requested when you switch from user execute mode to privileged mode. Remember to share the password you have created with only those authorized to configure the network. ISTANBUL(config)#enable password cisco123 You can use the enable password “password” command to set a password for the Cisco Router. You must set the Enable password to restrict or prevent unauthorized access to your router.Įnable Password sets a password when you switch to the Privileged Execute Mode at the router’s CLI command prompt. ISTANBUL(config)#interface fastethernet 0/0

If you want to close the interface, you should only use the shutdown command. No shutdown command opens the closed interface. Then use the no shutdown command to make the port available.

Gns3 add cisco switch